![smith and wesson model 10-5 date of manufacture smith and wesson model 10-5 date of manufacture](https://images.guns.com/prod/2020/04/13/5e949fb1bca79b7b2be7d08e3e27fbf9bdfb394fdb26c.jpg)
I will ask around and try to pin the date down a little closer for you.
SMITH AND WESSON MODEL 10 5 DATE OF MANUFACTURE FREE
It is essential for safety that you return these obsolete L-frame hammer noses and obsolete L-frame hammer assemblies for a free exchange to: Superseded parts should never be fitted into a modified revolver as this may result in malfunction. This obsoletes all old L-frame hammer noses (part numbers 47) and all old L-frame hammer assemblies (part numbers 3366, 3378, 3380, 3382, 3391, 4722, 4723, 47) in field parts inventories. One of the modifications to improve the L-frame revolver is the installation of a new hammer nose. Other users should send their revolvers to a Smith & Wesson Warranty Service Center, specifying "L-frame improvement program" and enclosing their name and return address. Law enforcement agencies wishing to arrange for modification of L-frame revolvers should call 80 between 9 A.M. Smith & Wesson will modify your L-frame revolver free of charge to eliminate the possibility of cylinder binding with. If your revolver bears the model number 581, 586, 681, 686, or 581-1, 586-1, 681-1, 686-1, 686CS-1 without an "M" over the model number, it does not include this improvement and your should have your revolver modified. If your revolver has been stamped either with a "2" or higher number after the basic three-digit model number or with an "M" above the model number, your revolver includes this improvement and does not need modification. You can check if your revolver includes this improvement by looking at the left side of the frame when the cylinder is fully open. Shipments of L-frame revolvers from our factory after Augalready include this improvement. 357 Magnum ammunition, without cylinder binding. This improvement enables them to fire all. Smith & Wesson has developed a modification to improve existing L-frame revolvers. Those who need to use their L-frame revolver under these conditions prior to modification can safely fire. 357 Magnum ammunition with an L-frame revolver bearing model numbers 581, 586, 681, 686 or 581-1, 586-1, 681-1, 686-1, 686CS-1 without an "M" over the model number until you have had the revolver modified. In a situation where a failure to fire can be critical - such as law enforcement or personal protection - do not use. 357 Magnum ammunition with increased velocity and greater primer sensitivity.Īlthough there have been very few reported incidents of cylinder binding, in view of our concern for our customer's safety and the reliability of Smith & Wesson products in all circumstances, we issue the following warning: Recent developments in ammunition manufacture emphasize the production of. Mishandling a revolver while freeing the cylinder can result in accidental discharge.Ĭylinder binding can result from a number of causes, including characteristics of an individual revolver or the use of ammunition, which does not conform to industry pressure specifications or is particularly fast burning. L-frame revolvers bearing model numbers:Ĭylinder binding can cause a failure to fire. 357 Magnum ammunition has resulted in unacceptable cylinder binding.
![smith and wesson model 10-5 date of manufacture smith and wesson model 10-5 date of manufacture](https://dygtyjqp7pi0m.cloudfront.net/i/13268/13828410_3.jpg)
RECALL: Reports have been received from the field where the combination of a SMITH & WESSON L-FRAME 357 MAGNUM REVOLVER and some.